Well if you have seen this set of 5 stained glass stencils from Claritystamp you will immediately recognize these.
I attached the stencil to a piece of black card with masking tape only from the top. I spread white acrylic paint over small gelli plate and layed down card with stencil attached an pulled a print thus creating base. Then i put some yellow paint on top third of plate and as there was image i could see where i wanted it and pulled another impression on top.Then i just lifted card off without unhinging it and put some ink through stencil where hills are. Before laying back card i cleaned the stencil so not to smudge card and pulled this print.
Finally i did same with brown paint and lower part of stencil. And that is print finished.
I stamped same stamp on white shrink plastic and cut it out and heated it with heat gun and obtained white embellishment in corner. I trimmed topper down and matted and layered and stuck to A5 card.
For the sentiment I used the Clarity banner which i stamped in black archival and embossed in clear detail powder.
First card ready.
Here are some other versions;
I hope you like these. I really enjoyed making them so feel free to leave comments which i truly appreciate, Theresa xx